Drawer Front Resize

When I built the Electronics Bench, I screwed up when cutting the drawer fronts.   Two of the drawers ($2, #4) were too short, so I cut another strip same thickness and length, then edge joined it to the top of the drawer.    

Note from this pic drawers #2 and #4 are too short.  



Here is drawer #2 with it's front extension, slotted and biscuited.   Note the handle has also been removed, it will be replaced higher so it is the same distance from the drawer front top as the other drawers.



Little different angle.   When I started, I ran the drawer front and the extension across the jointer.



Close up showing a biscuit and it's slot.  



In the glue clamps.  



From the front, its difficult to see the crack between drawer front and extension.  



Closer look if you look close you can see the crack, but sanding will make it disappear.  



Electronics bench with drawer fronts #2 & #4 extended.  



Close up of Drawer #2's top, you can just barely see the difference in wood grain.   But you can't feel it.



Top of drawer #4, again you can just barely see the difference in wood grain.